Skoda ENYAQ iV 2020 Owner's Manual page 218

216 12 volt vehicle battery and fuses ›
Use another vehicle's 12 volt vehicle battery to operate
the vehicle
WARNING
Risk of injury! Danger of damage to vehicle!
Lay the jump start cables so that they cannot become caught
▶
by rotating parts in the engine compartment.
NOTICE
Short circuit!
The non-insulated parts of the terminal clamps must not touch
▶
each other.
The cable connected to the positive pole of the 12 volt vehicle
▶
battery must not come into contact with electrically conduc-
tive vehicle parts.
The vehicles must not touch each other.
▶
Connect the jump start cable
›
Switch off the ignition.
›
Connect the terminal clamps of the jump start cables in the or-
der shown in the legend.
discharged 12 volt vehicle battery
Using the jump-starting cable
1
2
3
4
Under the front flap: Ground point /
tery (under the cover cap)
Start the vehicle
›
Start the engine of the current-giving vehicle and let it idle (ap-
plies to vehicles with combustion engine)
Or:
›
Switch on the electric drive of the vehicle supplying power
(applies to vehicles with an electric motor).
›
Switch on the ignition of the vehicle with the discharged 12
volt vehicle battery.
current-supplying 12 volt vehicle battery
-pole of the discharged 12-volt vehicle battery
-pole of the current-supplying 12 volt vehicle battery
-pole of the current-supplying 12 volt vehicle battery (or
earth point)
Earth point of the vehicle with discharged 12 volt vehicle
battery
-pole of the 12-volt vehicle bat-