Table of Contents
Advertisement
›
Using the functional surfaces
control display menu.
›
Tap on the functional surface
›
Then follow the instructions on the screen.
Save the tyre pressures in the following cases:
Change of tyre pressure
▶
Change of one or more wheels
▶
Change of position of a wheel on the vehicle
▶
Always after covering a distance of 10,000 km or
▶
once a year
Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
›
Stop the vehicle, switch off the ignition and
start the engine.
If the symbol
flashes again after starting the en-
gine, there is a system fault.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
Installing
›
Push the cover cap onto the wheel bolt to the stop.
Full wheel frame
Removing and installing the trim
Applies to factory built or original accessory trims
from ŠKODA.
Disconnecting
›
Hang the clamps for removing the wheel trims at
the edge of one of the openings in the trim.
›
Push the wheel wrench through the clamp, support
on the tyre and pull off the wheel trim.
select the tyre
.
›
Push the pull-off clamp
onto the cover cap up
to the stop.
›
Remove the cover cap.
Wheels ›
Wheel bolt cover caps
Installing
›
Press the wheel trim onto the wheel rim at the
designated valve opening.
When using an anti-theft wheel bolt, it must be lo-
cated at the location indicated on the bezel.
›
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
NOTICE
Use hand pressure, do not hit the wheel cover.
▶
169
Advertisement
Table of Contents
