IBM E Server i Series Manual page 96

v If you do not have another device to sign on to the system, but do have an
v If you cannot use another service tools device or service tools device ID to sign
90
iSeries: iSeries Access for Windows Operations Console
3. Type 2 in front of the service tools device ID to be reset, and then press
Enter.
4. Press Enter again to confirm the reset.
Note: When you reset the password in DST, the service tools device ID
password becomes the service tools device ID name in uppercase. If
you will be using a password other than the device name, you will
have to delete the current service tools device ID and create a new
ID with your desired password.
– If you do not want your service tools device ID name and service tools device
ID password to be the same, delete the service tools device ID and create a
new service tools device ID with a password of your choice. To do this,
perform these steps from the DST main menu:
1. Select Work with DST environment.
2. Select Service tools device IDs.
3. Type 3 in front of the old service tools device ID you want to delete, and
then press Enter.
4. Press Enter again to confirm the deletion.
5. Using option 1 create a new service tools device ID and assign the
password of your choice.
unused service tools device ID, do the following on the PC:
1. Delete the current configuration as follows:
a. Select the configuration name (under iSeries connection).
b. From the Connection menu, click Delete.
c. Click Yes to confirm the deletion.
2. Create a new configuration and use the unused service tools device ID
during the configuration.
3. Use one of the methods above to reset the failing service tools device ID after
connecting.
on and you are using the QCONSOLE service tools device ID, you will have to
use the control panel to reset the service tools device ID password by following
these steps:
1. Place the system in Manual mode. Systems without a keystick will show 01
B in the Function/Data display.
Note: Systems with a keystick should show the mode as Manual and 01 B in
the Function/Data display.
2. Use one of the following methods to reset the QCONSOLE service tools
device ID depending on the partition type:
– For independent systems or primary partitions follow these steps:
a. From the control panel, use the Up or Down buttons so that
Function/Data display shows 25. Then press the Enter button. The
Function/Data display should show 25 00.
b. Use the Up button once to increment the data to 26. Then, press the
Enter button. The system will most likely respond with 01 B in the
Function/Data display.
Note: If the system responds with 65 FF repeat steps a and b again.