IBM E Server i Series Manual page 69

To reset the 7855 modem for synchronous use, follow these steps:
1. Press the Right-arrow and Left-arrow buttons, at the same time, until Exit
Enter is shown.
2. Press the Right-arrow button.
3. Press the Down-arrow button until First Setup is shown.
4. Press the Right-arrow button.
5. Press the Down-arrow button until Reset to Factory is shown.
6. Press the Right-arrow button.
7. Press the Left-arrow button at Profiles Only and the light should briefly light
and return you to First Setup.
8. Press the Left-arrow button, and Exit Enter shows.
9. Press the Left-arrow button, and Remain Unlocked shows.
10. Press the Left-arrow button, and Save Profile 0 shows.
11. Press the Left-arrow button to complete the configuration change.
To reset the 7857 modem for synchronous use, follow these steps:
1. Press the Down-arrow button until Configurations is shown.
2. Press the Right-arrow button, and Select Factory shows on the bottom line.
3. Press the Enter button, and an underscore shows.
4. Press the Up-arrow button until 3 is shown. At this point, 3 begins to alternate
with the cursor.
5. Press the Enter button, and IBM 7857 V25BIS aa shows.
To reset the 7852 modem for synchronous or asynchronous use, use the switch
settings below:
1 16
UUDDUUUDDUDUUUUU
(Where U=up and D=down.)
Reset the modem for asynchronous use: Use this section for resetting the 7855, 7857,
and 7852 modems for asynchronous use.
To reset the 7855 modem for asynchronous use, follow these steps:
1. Press the Right-arrow and Left-arrow buttons (at the same time) until Exit
Enter is shown.
2. Press the Right-arrow button.
3. Press the Down-arrow button until First Setup is shown.
4. Press the Right-arrow button.
5. Press the Down-arrow button until Reset to Factory is shown.
6. Press the Right-arrow button.
7. Press the Left-arrow button at Profiles Only. The light should briefly light
and return you to First Setup.
8. Press the Right-arrow button.
9. Press the Down-arrow button until Asynchronous AT is shown.
10. Press the Left-arrow button, and First Setup shows.
11. Press the Right-arrow button.
12. Press the Down-arrow button until Power on Profile is shown.
13. Press the Right-arrow button, and Profile NVM 0 shows.
Chapter 4. Set up Operations Console
63