IBM E Server i Series Manual page 58

2. If you are currently in the Modems folder, click Add, and then Next.
3. When the window shows the modem it found, click Next to accept it. The PC
4. Click Finish to return to the Modems folder.
5. Close the Modems folder.
6. If you get a message that indicates that you need to restart the PC before you
7. If you were not prompted to restart the PC, restart the PC to force a rewrite of
Install PC modem for Windows NT
If you are installing a PC modem that requires specific drivers, use the instructions
that the modem manufacturer provides. Otherwise, follow these steps to install the
PC modem:
1. Click Start —> Settings —> Control Panel —> Modems.
2. If you are currently in the Modems Properties window click Add, and then
3. When the window shows the modem it found, click Next to accept it. The PC
4. Click Finish to return you to the Modems Properties window.
5. Close the Modems Properties window.
Install PC modem for Windows 2000
If you are installing a PC modem that requires specific drivers, use the instructions
that the modem manufacturer provides. Otherwise, follow these steps to install the
PC modem:
1. Click Start —> Settings —> Control Panel —> Phone and Modem Options.
2. If you are currently in the Modems tab of the Phone and Modem Options
3. When the window shows the modem it found, click Next to accept it. The PC
4. Click Finish to return you to the Phone and Modem Options folder.
5. Close the Phone and Modem Options folder.
6.
52
iSeries: iSeries Access for Windows Operations Console
Otherwise, if you are at the Install New Modem window, click Next. The PC
should find the new modem and report its location.
will now load the driver code to support it.
can use the modem, click OK. Then, perform a shutdown and restart your PC.
Otherwise, you may be prompted to restart your PC. If so, click Yes or OK to
perform the shutdown.
changed data.
Next. Otherwise, if you are at the Install New Modem window, click Next. The
PC should find the new modem and report its location.
will now load the driver code to support it.
Note: You must add and configure this modem in Remote Access Service
before the modem can be used by Operations Console.
folder, click Add and then click Next. Otherwise, if you are at the Install New
Modem window, click Next. The PC should find the new modem and report its
location.
will now load the driver code to support it.
If you get a message that indicates that you need to restart the PC before you
can use the modem, click OK. Then, perform a shutdown and restart your PC.
Otherwise, you may be prompted to restart the PC. If that is the case, click Yes
or OK to perform the shutdown.
Note: If you were not prompted to restart the PC, restart the PC to force a
rewrite of changed data.