Motion Search Dialog Box - Bosch LTC-1311-20 Operator's Manual

58 en | Reference information
11.23

Motion Search dialog box

Main window >
Allows you to set up a search filter for motion in designated areas of a camera image. You
select the zones where you want to detect motion. You can search for motion only in the
selected Image pane.
Start:
Enter date and time for starting the search for motion. Clear the check box if you want the
search start at the very beginning of the recording.
End:
Enter date and time for finishing the search for motion. Clear the check box if you want the
search stop at the present point in time.
Select All
Click to select the whole image.
Clear Selection
Click to remove the selection.
Operator Client | V3 | 2010.07
Click to display the Select Search Parameters dialog box.
Section 8.12 Finding Logbook entries
Click to display the Motion Search dialog box.
Section 8.11 Finding motion (only NVR recordings)
Click to display the Export Video dialog box.
Section 8.8 Exporting video data
Displays all cameras displayed in the Image window.
Displays the Timelines of the cameras in the camera list.
Allows you rapid time positioning for playing the corresponding videos.
Section 8.1 Using the Timeline
Section 8.8 Exporting video data
Section 8.11 Finding motion (only NVR recordings)
Section 8.13 Finding recorded video data
Section 8.4 Authenticating video data (for NVR recordings only)
Section 8.6 Protecting video
Section 8.7 Deleting video data
> tab
Operator's Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH