Starting The Keyboard; Entering Operation Modes; Displaying Cameras - Bosch LTC-1311-20 Operator's Manual

Bosch Video Management System
If the keyboard is connected to a decoder, the feature set is reduced. Only the analog mode is
available.
10.2.1

Starting the keyboard

The keyboard must be connected to a COM port of a workstation.
1.
2.
3.
10.2.2

Entering operation modes

You can use the keyboard in the following modes:
–
–
–
To enter Selection Mode:


To enter PTZ Mode:
1.
2.
To enter Jogshuttle Mode:
1.
2.
To leave PTZ or Jogshuttle Mode:

10.2.3

Displaying cameras

Enter a numeric command to display the camera with this logical number in the active Image
pane or analog monitor.
Toggling between analog mode and workstation mode

Displaying a camera in a computer monitor
1.
2.
Bosch Sicherheitssysteme GmbH
Start the Operator Client on the workstation.
Press the Prod button.
The keyboard scans for connected devices.
Press the Terminal softkey.
The Selection Mode is displayed.
Selection Mode
This mode allows you to select an Image pane by moving the joystick in the desired
direction.
PTZ Mode
This mode allows you to control fixed and PTZ cameras, maps, and documents in Live
Mode.
Jogshuttle Mode
This mode allows you to control cameras in instant playback or in Playback Mode.
Start the Operator Client and the keyboard.
or
Press ENTER to leave PTZ or Jogshuttle Mode and to return to Selection Mode.
Select a PTZ camera.
Press Shot.
To start a preposition, press Shot again, press the number of a preposition, and press
ENTER.
Start Playback Mode.
Press Shot.
Press ENTER to leave PTZ or Jogshuttle Mode and start Selection Mode again.
Press Mon twice.
Switch to a digital mode.
Press Mon, press 1 - 4 to select the desired workstation monitor, press the number of
the desired Image pane and press ENTER.
The numbering of Image panes is from left to right and top to bottom.
Operator's Manual
Using a CCTV keyboard | en
Operator Client | V3 | 2010.07
35