Bosch LTC-1311-20 Operator's Manual page 67

Bosch Video Management System
5.
6.
Auto pop-up alarms
Alarms can be configured to automatically display (pop up) in the Alarm Image window, based
on the alarm priority. Each user group's live and playback displays are also assigned priorities.
When alarms are received with priority higher than that of the user's display, the alarm
automatically displays its alarm row in the Alarm Image window. If the Alarm Image window is
not currently displayed, it automatically replaces the Live or Playback Image window on the
alarm-enabled monitor.
Although auto pop-up alarms are displayed in the Alarm Image window, they are not
automatically accepted. They can be displayed on multiple users' displays simultaneously.
When a user accepts an auto pop-up alarm, it is removed from all other users Alarm Lists and
alarm displays.
Bosch Sicherheitssysteme GmbH
Image window. You can step through the stacked alarms with the controls at the left side
of the alarm row.
You can step through the alarm stacks on analog monitor groups with control buttons in
the Monitors window of the Operator Client workstation display. Analog monitors in
alarm are indicated by red icons with blinking "LEDs".
The alarm title, time, and date can be optionally be displayed on all analog monitors, or
only the first monitor in the alarm row.
For equal priority alarms, the administrator can configure the order behavior:
– Last-in-First-out (LIFO) mode: in this configuration, new alarms are inserted above
older alarms of the same priority.
– First-in-First-out (FIFO) mode; in this configuration, new alarms are inserted below
older alarms of the same priority.
An alarm's Image row can appear in the Alarm Image window in one of two ways:
– When it is generated (auto pop-up). This occurs when the alarm priority is higher
than display priority.
– When the alarm is accepted. This occurs when the alarm priority is lower than
display priority.
Operator's Manual
Concepts | en 67
Operator Client | V3 | 2010.07