Monitors Window; Image Window - Bosch LTC-1311-20 Operator's Manual

54 en | Reference information
non-PTZ camera is selected.
directions.
(wide angle).
Prepositions:
Select an entry to move the PTZ control to the predefined position.
Click to save the current position of the PTZ camera to the selected preposition entry.
AUX Commands:
Select an entry to execute this command.
11.19

Monitors window

Main window >
Displays the available analog monitor groups. This tab is only visible if at least one analog
monitor group is configured and the analog monitor group is assigned to this workstation. If
the computer is not configured as a workstation, this assignment is not required.
Allows you to switch to the next or to the previous analog monitor group.
Allows you to switch to the previous or next alarm when there are more alarm cameras than
available monitors.
11.20

Image window

Main window
Operator Client | V3 | 2010.07
Click to zoom in or out digitally. These controls are active even when a
Click an arrow or drag the joystick in the center to swivel the camera in all
Click to zoom in the picture angle (zoom angle) / zooming out the picture angle
Click to set the focus near / focus far.
Click to close the iris / open the iris.
> Monitors tab
Operator's Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH