Bosch LTC-1311-20 Operator's Manual page 37

Bosch Video Management System
To toggle between Tree Mode and Command Mode:


To use the Logical Tree mode:

Right side of the softkey display:

Left side of the softkey display:



The following figures show an example of a Logical Tree and its representation on the softkey
display of the keyboard.
To use the Command Mode:
1.
2.
The following commands are available:
–
–
–
–
–
Bosch Sicherheitssysteme GmbH
In the Tree Mode: Press the left Level Up softkey as often as needed to display the root
level and then press the Exit softkey to display the Command Mode.
or
In the Command Mode: Press the Tree Mode softkey.
Switch to the Tree Mode.
Press a softkey to control the item (e.g. display a camera or switch a relay).
When you press a map or a folder (black background), it moves to the left side. The right
side displays the its content.
Press a softkey on the left side to select a folder or a map and to display its content on
the right side of the softkey display.
To display a map, press the softkey once to mark it (with a rectangle) and press the
softkey again to display it in the selected Image pane.
Press Level Up to enter the next upper level of the Logical Tree.
Press UP to move the selection upward or DOWN to move downward.
Switch to the Command Mode.
Press a softkey to execute the desired command.
: Load a sequence. In the Status Display, enter the sequence number.
: Sequence play, pause
/ : Sequence step forward / backward
: Maximize / restore selected Image pane
: Close selected Image pane
Operator's Manual
Using a CCTV keyboard | en
Level Up Camera2
Map1
Camera1
Map2
Folder1
Map3
DOWN DOWN
Operator Client | V3 | 2010.07
37