Tilt Lever - Suzuki DF350A Owner's Manual

TILT LEVER

The Tilt Lever is provided so you can support
the motor in a tilted position for non-moving
engine support.
To set the Tilt Lever:
1. Tilt the motor all the way up by pressing the
Power Trim and Tilt "UP" switch.
2. Pull down the Tilt Lever as shown in the illus-
tration.
3. Lower the motor by pressing the Power Trim
and Tilt "DOWN" switch, until the motor is
supported by the Tilt Lever.
4. Continue to operate the Power Trim and Tilt
"DOWN" switch until the trim rods are com-
pletely retracted.
54
NOTICE
If you do not retract the trim rams com-
pletely when mooring, they may become
deteriorated or corroded.
Be sure to retract the trim rams com-
pletely when mooring.
To release the Tilt Lever, tilt the motor all the
way up using the Power Trim and Tilt "UP"
switch, and pull up the Tilt Lever.
If equipped with Keyless Start System:
 CAUTION
The remote Power Trim and Tilt switch
will work when the Keyless start system
is off. If someone activates the switch
while you are moving the tilt bracket, your
hand could be injured.
Keep all persons away from the remote
Power Trim and Tilt switch while you are
moving the tilt lever.
NOTICE
Damage can occur if you use the tilt lever
other than when the boat is moored or is
otherwise stationary.
The tilt lever relieves pressure from the
power trim and tilt and should only be
used when the boat is stationary. Do not
use the tilt lever when trailering your boat
and motor. Refer to the TRAILERING sec-
tion of this manual.