Suzuki DF350A Owner's Manual page 21

6. Pull out the emergency stop switch lock
plate.
7. Within eight (8) seconds after performing
Step 5, start the following operation.
(1) Turn the main switch to the "
hold it for about five (5) seconds then
release it to the "
Repeat this operation for two more times.
The buzzer sounds once and the system
enters stand-by mode for passcode input.
NOTE:
The buzzer will not sound if the operation in
Step (1) is not performed within eight (8) sec-
onds or the operation fails.
Hold it for five (5) seconds.
" position and
" position.
(2) Within 60 seconds after performing Step (1),
turn the main switch to the "
then release it. The main switch automati-
cally returns to the "
The buzzer starts emitting short sounds.
Briefly turn the switch after the number of
sounds that is the same as the first pass-
code digit. For example, if the first passcode
digit is seven, turn the switch after the sev-
enth sound.
To set or select zero (0), turn the switch after
the 10th sound.
NOTE:
If the operation in Step (2) is not performed
within 60 seconds after performing Step (1), the
passcode input operation will be cancelled and
the buzzer will sound three (3) times.
Example: When entering 7
1 2 3 4 5
After the buzzer emits 10 sounds, it emits one
long sound before to returning to stand-by
mode for the second passcode digit.
(3) Repeat Step 2 to enter the second, third and
fourth passcode digits.
(4) After entering the fourth pass code digit, the
buzzer emits one continuous sound – within
60 seconds, turn the switch ON and hold it
for five (5) seconds until the buzzer stops,
then release it.
" position and
" position.
6 7 8 9 10 11
19