Passcode Confirmation - Suzuki DF350A Owner's Manual

(6) Install the lock plate on the emergency stop
switch.
(7) Turn the main switch to the "
then release it to the "
Keyless Start System OFF.
After that, do not perform any operation for
at least 30 seconds, while the system per-
forms passcode update.

PASSCODE CONFIRMATION

1. Confirm that the engine is stopped.
2. Make sure the emergency switch lock plate
is in place.
3. Confirm the key-fob is within the communi-
cation range of the Keyless Start System.
4. Confirm the key-fob is in ON mode. (Refer to
"Switching the communication mode of the
key-fob" section.)
5. Turn the main switch to the "
then release it. The main switch automati-
cally returns to the "
The buzzer on the engine control side emits
one (1) long sound while the buzzer on the
keyless control unit side emits two (2) short
sounds simultaneously.
" position and
" position to turn the
" position and
" position.
6. Within eight (8) seconds after performing
Step 5, start the following operation.
(1) Turn the main switch to the "
hold it for five (5) seconds or longer, then
release it to the "
Repeat this operation for two more times.
Hold it for five (5) seconds.
(2) The LED on the key-fob blinks once and the
buzzer sounds once.
After that, the LED on the key-fob blinks to
indicate the passcode by the number of
blinks, as shown in the illustration.
This is indicated repeatedly.
NOTE:
The passcode indication will not start if Step (1)
is not performed within eight (8) seconds or the
operation fails.
In this case, turn the main switch to the "
position and then release it to the "
to turn the Keyless Start System OFF. After
that, retry the procedure from Step 5.
Example: In the case of passcode 1234
LED
" position and
" position.
" position
"
21