Suzuki DF350A Owner's Manual page 62

NOTE:
On a boat equipped with quadruple engines,
use two control panels which are for dual
engine. When operating the SELECT, THROT-
TLE ONLY and SYNC function, all four engines
are controlled by either control panel switch.
Start & Stop Switch
This is a switch to start and stop the engine.
The engine can be started with the remote con-
trol handle at the neutral position.
Station Select Switch
This switch control between driving stations on
boats equipped with more than one driving sta-
tion.
When pushing the select switch to select sta-
tion, SELECT LED on the control panel at the
driving station selected comes on, and the
SELECT LED at the driving station not selected
goes out.
This switch is enabled only when the remote
control handle at the 1st and 2nd driving sta-
tions are at the neutral position.
NOTE:
If equipped with Keyless Start System:
When the Keyless Start System has been
turned to ON state by operating the main
switch, the 1st driving station is automatically
selected. By operating this switch with the
remote control handle in positions other than
the neutral, the SELECT LED blinks and the
buzzer sounds at the same time.
If not equipped with Keyless Start System:
When the main switch is turned ON, the 1st
driving station is automatically selected. By
operating this switch with the remote control
handle in positions other than the neutral, the
SELECT LED blinks and the buzzer sounds at
the same time.
60
NOTE:
• When pushing the SELECT switch to select
station, continue to push SELECT switch until
the buzzer sounds one short beep.
• If equipped with Keyless Start System:
If failed to switch from the 2nd station to the
1st station, operate the main switch to turn
the Keyless Start System to OFF state and
wait for 20 seconds, and then turn it back to
ON state again.
If not equipped with Keyless Start System:
If selecting the 1st station returning from the
2nd station is failed, turn OFF the main
switch then turn ON it after 20 seconds past.
• Consult your authorized Suzuki marine
dealer if the station can not be selected.
Throttle Only Switch
This switch holds the shift position in neutral,
thereby allowing operation the throttle without
changing the shift position. When the shift posi-
tion is hold in neutral, the THROTTLE ONLY
LED comes on and when the switch is
released, the THROTTLE ONLY LED goes out.
The throttle only switch is only enabled when
the remote control handle is in the neutral posi-
tion.
NOTE:
If this switch is operated with the remote control
handle in a position other than neutral, the
THROTTLE ONLY LED blinks and a buzzer
sounds at the same time.