Brocade Communications Systems 53-1001763-02 Administrator's Manual page 505

1. Log in to the switch or director as admin and enter the version command. Verify that Fabric OS
2. Perform the following appropriate action based on the hardware model you are configuring:
3. If you are configuring EX_Ports on the 8-Gbps port blades on the Brocade DCX or DCX-4S
4. Enter the interopMode command and verify that Fabric OS switch interoperability with switches
Fabric OS Administrator's Guide
53-1001763-02
v6.4.0 is installed on the FC router as shown in the following example.
switch:admin> version
Kernel: 2.6.14.2
Fabric OS: v6.4.0
Made on: Fri Jan 22 01:15:34 2010
Flash: Mon Jan 25 20:53:48 2010
BootProm: 1.0.9
•
If you are configuring the Brocade 48000 director, enter the slotShow command to verify
that the FR4-18i blade is present. Proceed to
•
If you are configuring the Brocade DCX or DCX-4S, enter the slotShow command to verify
that either the FR4-18i or FX8-24 blade is present or, if configuring EX_Ports on an 8-Gbps
port blade, that the FC8-16, FC8-32, FC8-48, or FC8-64 blade is present. The following
example shows slot 2 with the FR4-18i blade and slots 3, 9, 10, and 12 with 8-Gbps port
blades enabled. Proceed to
•
If you are not configuring a Brocade 48000, Brocade DCX, or Brocade DCX-4S platform,
then skip to step 4.
switch:admin> slotshow -m
Slot Blade Type
--------------------------------------------------
1 AP BLADE
2 AP BLADE
3 SW BLADE
4 SW BLADE
5 CORE BLADE
6 CP BLADE
7 CP BLADE
8 CORE BLADE
9 SW BLADE
10 SW BLADE
11 UNKNOWN
12 SW BLADE
See Chapter 3, "Performing Advanced Configuration Tasks,"
corresponding IDs.
(FC8-16, FC8-32, FC8-48, FC8-64, or FX8-24), enter the licenseShow command to verify that
the Integrated Routing license is installed.
switch:admin> licenseshow
S9bddb9SQbTAceeC:
Fabric license
bzbzRcbcSc0c0SY:
Remote Fabric license
RyeSzRScycazfT0G:
Integrated Routing license
If the Integrated Routing license is not installed, you must install it, as described in
"Administering Licensing".
from other manufacturers is disabled.
switch:admin> interopmode
Setting up the FC-FC routing service
step
step 3.
ID Model Name
33 FA4-18
24 FR4-18i
37 FC8-16
39 FC10-6
52 CORE8
50 CP8
50 CP8
52 CORE8
37 FC8-16
55 FC8-32
51 FC8-48
3.
Status
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
VACANT
ENABLED
for a list of blades and their
21
Chapter 16,
465