Setting Traffic Prioritization Over Fc Routers - Brocade Communications Systems 53-1001763-02 Administrator's Manual

Example

Setting traffic prioritization over FC routers

1. Connect to the switch in the edge fabric and log in as admin.
2. Create QoS zones in the edge fabric.
3. Create LSAN zones in the edge fabric.
4. Enter the portCfgQos command to enable QoS on the E_Ports (or VE_Ports).
5. Repeat
6. Connect to the FC router in the backbone fabric and log in as admin.
7.
Fabric OS Administrator's Guide
53-1001763-02
sw0:admin> zonecreate "QOSH1_zone", "10:00:00:00:10:00:00:00;
10:00:00:00:20:00:00:00"
sw0:admin> zonecreate "QOSL2_zone", "10:00:00:00:30:00:00:00;
10:00:00:00:40:00:00:00"
sw0:admin> zoneshow
sw0:admin> cfgadd "cfg1", "QOSH1_zone"
sw0:admin> cfgadd "cfg1", "QOSL2_zone"
sw0:admin> cfgshow
Defined configuration:
cfg: cfg1 zone1; QOSH1_zone; QOSL2_zone
zone: QOSH1_zone
10:00:00:00:10:00:00:00; 10:00:00:00:20:00:00:00
zone: QOSL2_zone
10:00:00:00:30:00:00:00; 10:00:00:00:40:00:00:00
zone: zone1 10:00:00:00:10:00:00:00; 10:00:00:00:20:00:00:00;
10:00:00:00:30:00:00:00; 10:00:00:00:40:00:00:00
Effective configuration:
No Effective configuration: (No Access)
sw0:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only?
Updating flash ...
sw0:admin> cfgenable "cfg1"
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected. If the update includes changes
to one or more traffic isolation zones, the update may result in
localized disruption to traffic on ports associated with
the traffic isolation zone changes
Do you want to enable 'cfg1' configuration
zone config "cfg1" is in effect
Updating flash ...
sw0:admin> portcfgqos --enable 3
The QoS zones must have WWN members only, and not D,I members. See
prioritization" on page 414 for instructions.
See "Controlling device communication with the LSAN"
step 1 through step 3
Enter the portCfgQos command to enable QoS on the EX_Ports (or VEX_Ports).

Setting traffic prioritization over FC routers

(yes, y, no, n): [no] y
to create QoS zones and LSAN zones on the other edge fabric.
(yes, y, no, n): [no] y
"Setting traffic
on page 478 for instructions.
18
415