Enabling The Dcc Policy On A Trunk Area - Brocade Communications Systems 53-1001763-02 Administrator's Manual

Enabling the DCC policy on a Trunk Area

After you assign a Trunk Area, the portTrunkArea CLI checks whether there are any active DCC
policies on the port with the index TA, and then issues a warning to add all the device WWNs to the
existing DCC policy with index as TA.
All DCC policies that refer to an Index that no longer exists will not be in effect.
1. Add the WWN of all the devices to the DCC policy against the TA.
2. Enter the secPolicyActivate command to activate the DCC policy.
3. Turn on the trunk ports.
You can configure authentication on all three Brocade trunking configurations. For more
information on authentication, see
Fabric OS Administrator's Guide
53-1001763-02
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
38->1
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
37->1
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
36->1
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
You must enable the TA before issuing the secPolicyActivate command in order for security to
enforce the DCC policy on the trunk ports.
Trunk ports should be turned on after issuing the secPolicyActivate command to prevent the
ports from becoming disabled in the case where there is a DCC security policy violation.
F_Port masterless trunking
sp: 8.000G bw: 8.000G deskew 15
sp: 8.000G bw: 8.000G deskew 15
sp: 8.000G bw: 8.000G deskew 15
Chapter 7, "Configuring Security Policies".
19
439