Brocade Communications Systems 53-1001763-02 Administrator's Manual page 488

20
Buffer credit management
NOTE
The portCfgLongDistance command's desired_distance parameter is the upper limit of the link
distance and is used to calculate buffer availability for other ports in the same port group. When the
measured distance exceeds the value of desired_distance, this value is used to allocate the buffers.
In this case, the port operates in degraded mode instead of being disabled due to insufficient
buffers. In LS mode, the actual link distance is not measured; instead, the desired_distance value
is used to allocate the buffers required for the port.
Refer to the data in
switch or blade, number of user ports in a port group, and the unreserved buffer credits available
per port group. The values reflect an estimate, and may differ from the supported values in
Table
1. Determine the desired distance in kilometers of the switch-to-switch connection. This example
2. Determine the speed that you will use for the long-distance connection. This example uses 2
3. Use one of the following formulas to calculate the reserved buffers for distance:
Below are additional examples using different speeds all based on a distance of 50 km. The
distances and speeds are variables that can change based on how your network is set up:
•
•
•
•
Example : Consider the Brocade 300, which has a single 24-port port group and a total of 676 buffer credits
for that port group
The maximum remaining number of buffer credits for the port group, after each port reserves its
eight buffer credits, is:
448
Table 92
93.
uses 50 km.
Gbps.
•
If QoS is enabled:
(Reserved Buffer for Distance Y) = (X * LinkSpeed / 2) + 6 + 14
•
If QoS is not enabled:
(Reserved Buffer for Distance Y) = (X * LinkSpeed / 2) + 6
Where:
X = the distance determined in step 1 (in kilometers).
LinkSpeed = the speed of the link determined in step 2.
6 = the number of buffer credits reserved for Fabric Services, Multicast, and Broadcast
traffic. This is a static number.
14=the number of buffer credits reserved for QoS. This is a static number.
Based on the answers provided in steps 1 and 2, insert the numbers into the formula. The
formula should read as follows:
(50 km * 2 Gbps / 2) + 6 = 56 buffers, which is the number of buffers reserved for distance
If you have a distance of 50 km at 1 Gbps then, (50 km * 1 Gbps / 2) + 6 = 31 buffers
If you have a distance of 50 km at 2 Gbps then, (50 km * 2 Gbps / 2) + 6 = 56 buffers
If you have a distance of 50 km at 4 Gbps then, (50 km * 4 Gbps / 2) + 6 = 106 buffers
If you have a distance of 50 km at 8 Gbps then, (50 km * 8 Gbps / 2) + 6 = 206 buffers
676 – (24 * 8) = 484 unreserved buffer credits
Where:
on page 451 and Table 93 on page 452 to get the total ports in a
Fabric OS Administrator's Guide
53-1001763-02