Configuring An Extended Isl - Brocade Communications Systems 53-1001763-02 Administrator's Manual

Configuring an extended ISL

Before configuring an extended ISL, ensure that the following conditions are met:
•
•
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the switchDisable command.
3. Enter the configure command to set the switch fabric-wide configurations. You can set the
4. For 8 Gbps platforms only, enter the portCfgFillword command to set ARB as the fill word.
5. Enter the portCfgLongDistance command.
6. Repeat
Example
The following example configures slot 1, port 2 to support a 100 km link in LS mode and be
initialized using the extended link initialization sequence. This example is for an 8 Gbps platform.
Fabric OS Administrator's Guide
53-1001763-02
The ports on both ends of the ISL are operating at the same port speed, and can be configured
at the same distance level without compromising local switch performance.
NOTE
A long-distance link also can be configured to be part of a trunk group. Two or more
long-distance links in a port group form a trunk group when they are configured for the same
speed, the same distance level, and their link distances are nearly equal. For information on
trunking concepts and configurations, refer to
Only qualified Brocade SFPs are used. Only Brocade-branded or certain Brocade-qualified
SFPs are supported on the 8 Gbps platforms.
following fabric-wide settings:
(* = multiplication symbol)
Field Type
Domain Number
R_A_TOV Number
E_D_TOV Number
WAN_TOV Number
MAX_HOPS Number
portcfgfillword [slot/]port, mode
The mode parameter in this command must be set to 1 if the vc_translation_link_init
parameter in the portCfgLongDistance command (in the next step) is set to 1.
portcfglongdistance [slot/]port [distance_level] [vc_translation_link_init]
[desired_distance]
step 5 and step 4
extended ISL ports must be configured to the same distance level. When the connection is
initiated, the fabric will reconfigure.
switch:admin> portcfgfillword 1/2 1
switch:admin> portcfglongdistance 1/2 LS 1 100
Reserved Buffers =
Warning: port may be reserving more credits depending on port speed.
switch:admin> portshow 1/2
portName:
portHealth: OFFLINE
Chapter 19, "Managing Trunking
Default
1
1000
2000
0
7
for the remote extended ISL port. Both the local and remote
406
Configuring an extended ISL
Range
Varies
E_D_TOV * 2 to 120000
1000 to R_A_TOV/2
0 to R_A_TOV/4
7 to 19
20
Connections".
443