62Z7B000.book 6 ページ 2012年9月27日 木曜日 午前10時21分
dummyhead
dummyhead
GOVERNOR SYSTEM
CONTROL BASE ASSY.
DISASSEMBLY/ASSEMBLY
MANUAL OPERATION TYPE
Remove the control base assy (page 7-2).
CONTROL LEVER WASHER
ASSEMBLY:
Install the control lever washer by
aligning the cutout of the control
lever washer with the claw of the
control base.
LEVER SPRING
ASSEMBLY:
Note the installation direction.
SCREW (4 x 6 mm)
(If equipped)
WIRE HOLDER
(If equipped)
CONTROL LEVER
SPACER
CIRCLIP (5 mm)
(If equipped)
CONTROL LEVER
CONTROL BASE
CONTROL ADJUST
SPRING
SCREW
(GX270H: 5 x 28 mm,
GX390H1: 5 x 32 mm)
(If equipped)
ASSEMBLY:
Adjust the maximum
speed (page 7-8).
STOPPER COLLAR
SCREW (5 x 25 mm)
(If equipped)
(If equipped)
7-6
SELF-LOCK NUT (6 mm)
ASSEMBLY:
After tightening the nut fully,
loosen it 1–1/2 turns.
SCREW (4 x 6 mm)
(If equipped)
WIRE HOLDER
(If equipped)
CIRCLIP (5 mm)
(If equipped)
CLAW
CABLE RETURN SPRING
INSTALLATION:
Install with the short end of
the spring toward the
control base.
Hook the cable return
spring to the hole of the
control lever.