Honda GX270H Manual page 152

62Z7B000.book 9 ページ ２０１２年９月２７日 木曜日 午前１０時２１分
dummyhead dummyhead
1/2 REDUCTION CLUTCH TYPE
(GX270H ONLY)
REDUCTION CASE
ASSEMBLY:
Be careful not to damage the lip of the oil
seal when installing it onto the crankshaft.
DRIVE SPROCKET
ASSEMBLY:
Attach the drive chain to
the P.T.O. shaft and
sprocket and install in the
reduction case as a set.
CLUTCH
CENTER
BEARING (6206)
BOLT (6 x 50 mm) (9)
P.T.O. SHAFT OIL SEAL
(30 x 50 x 7 mm)
KEY (7 x 7 x 33 mm)
REDUCTION COVER
ASSEMBLY:
Be careful not to damage the lip of the oil
seal when installing the P.T.O. shaft into
the reduction cover.
REDUCTION OIL CAP/
OIL LEVEL GAUGE
O-RING
DOWEL
CLUTCH
PIN (2)
CENTER
KEY
THRUST
WASHER
BOLT (8 x 32 mm) (4)
DRIVE CHAIN
SPRING WASHER
P.T.O. SHAFT
SEALING WASHER
CRANKSHAFT OIL
SEAL (30 x 46 x 8 mm)
CLUTCH FRICTION DISC (2)
ASSEMBLY:
Note the installation sequence.
BEARING (6205)
CLUTCH WEGHT HOLDER Assy.
ASSEMBLY:
Align the groove of the clutch weight holder
with clutch center key when installing.
BOLT (8 x 35 mm)
REDUCTION COVER PACKING
OIL DRAIN BOLT
23 N·m (2.3 kgf·m, 17 lbf·ft)
CRANKCASE
CLUTCH PLATE (2)
ASSEMBLY:
Note the installation sequence.
14-9