Honda GX270H Manual page 172

62Z7B000.book 29 ページ ２０１２年９月２７日 木曜日 午前１０時２１分
dummyhead dummyhead
CRANKSHAFT OIL SEAL (30 x 46 x 8
mm)
Remove the oil seal from the reduction case.
Drive a new oil seal [1] in the position as shown using
the special tools.
TOOLS:
Attachment, 45 x 50 mm [2]
Driver handle [3]
Apply grease to the lip of a oil seal.
P.T.O. SHAFT BEARING (6205)
Pull out the P.T.O. shaft bearing [1] using the special
tools.
TOOLS:
Bearing remover shaft set,
25 mm [2]
Sliding hammer weight [3]
Drive a new P.T.O. shaft bearing [4] until it is fully
seated on the end using the special tools.
TOOLS:
Bearing driver attachment,
52 x 55 mm [5]
Pilot, 25 mm [6]
Driver handle [7]
REDUCTION COVER SIDE P.T.O.
SHAFT BEARING (6206)
REDUCTION COVER SIDE P.T.O. SHAFT BEARING
(6206)
Remove the oil seal and drive out the P.T.O. shaft
bearing.
Drive a new P.T.O. shaft bearing [1] until it is fully
seated on the end using the special tools.
TOOLS:
Bearing driver attachment,
62 x 64 mm [2]
Pilot, 30 mm [3]
Driver handle [4]
[3]
07946-6920100
07749-0010000
[2]
(Lips)
07936-ZV10100
07741-0010201
[3]
[2]
07746-0010400
07746-0040600
07749-0010000
[7]
[5]
[4]
07947-6340400
07746-0040700
07749-0010000
CRANKCASE
[1]
[1]
[4]
[2]
[3] [1]
14-29