Tests Menu - Furuno FCV-38 Manual

6. MAINTENANCE AND TROUBLESHOOTING
Error
Error name
Icon
Processor Unit
System Error
Transceiver Unit
System Error
6.7

Tests Menu

You can run a diagnostic test, or view detailed information about your equipment, from
the [Tests] menu.
To access the [Tests] menu, do the following:
1. Click the [Advanced Settings] icon (
the [Advanced Settings] icon (
2. Click [Tests] to show the [Tests] menu, on the right-hand side of the window.
FCV-38[ver 0252473-xx.xx]
6-6
Error
code
P01 The voltage of the battery inside the Proces-
sor Unit is low. Turn the equipment off, then
contact your local dealer to request replace-
ment of the battery.
P02 The fan is in the Processor Unit is rotating too
slowly. Turn the equipment off, then contact
your local dealer to request replacement of
the fan.
P05 Multiple alike IP addresses found. Turn the
equipment off, then contact your local dealer
for advice. (IP address setup is in the [Ser-
vice] menu.)
T01 Communication error between the Trans-
ceiver Unit and Processor Unit. Turn the
equipment off, then contact your local dealer
for service.
T03 The rotating speed of the FAN1 in the Trans-
ceiver Unit is abnormal. Turn the equipment
off, then contact your local dealer for service.
T04 The rotating speed of the FAN2 in the Trans-
ceiver Unit is abnormal. Turn the equipment
off, then contact your local dealer for service.
) to show the [Advanced Settings] window.
* These items are for maintenance/service
purposes and are not accessed normally.
Reason, remedy
) from the InstantAccess bar™, then click
Priority
Order
4
5
6
3
7
8
*
*
*