Nortel Communication Server 1000S Service Implementation Manual page 71

Procedure 13
Configuring the BGD terminal
1 Ensure that the BGD terminal was configured in the system software, as
described in "LD 17 – Define the BGD terminal port" on page 48.
2 Define the interface parameters of the BGD I/O card as follows:
• Transmission speed: 9600 bps
• Data bits:8
• Stop bit:1
• Parity:No
• Flow control:No
Note: The BDG terminal SDI port must be configured as DTE.
3 Configure the BGD terminal parameters. Refer to Table 11.
Table 11
BGD terminal parameters
Parameter
SET OPTION CONFIRM ON
SET OPTION PORT xx SET
ON
SET OPTION PORT xx
DISPLAY OFF
SET OPTION LANGUAGE xx
OFF
Note: The SET OPTION CONFIRM is set to OFF by default. It is
changed to ON because Hospitality Integrated Voice Services uses the
information sent back from the BGD SDI port.
4 Put the terminal in LOGOUT mode.
Hospitality Integrated Voice Services Service Implementation Guide
Installation and configuration
Description
The default is OFF. Change the
setting to ON.
xx is the device number, from 0–15,
defined at ADAN in LD 17.
xx is the same device number as
above, from 0–15.
x is the language number, from 0–5.
Do this for each language.
End of Procedure
Page 71 of 136