Install The Hospitality Integrated Voice Services Card - Nortel Communication Server 1000S Service Implementation Manual

Page 58 of 136 Installation and configuration

Install the Hospitality Integrated Voice Services card

553-3001-359 Standard 2.00 September 2004
4 Remove the existing filter connector from the I/O panel and save the
retaining screws.
This filter connector corresponds to the card slot selected for Hospitality
Integrated Voice Services card installation.
5 Install the NT5D52AC Ethernet adapter into the selected I/O panel
connector cut-out using the saved retaining screws.
See Figure 7 on
6 Fasten the I/O panel to the module using the retaining screws that was
removed earlier. Replace the module's cover plate.
Follow the steps in Procedure 6 to install the Hospitality Integrated Voice
Services card.
Procedure 6
Installing the Hospitality Integrated Voice Services card
1 Identify the IPE card slot selected for the Hospitality Integrated Voice
Services card.
2 Make sure that the hard drive PC Card is in the lower PC Card slot on the
faceplate, and that it is firmly seated.
3 Pull the top and bottom extractors away from the Hospitality Integrated
Voice Services card faceplate.
4 Insert the Hospitality Integrated Voice Services card into the card guides
and gently push the card until the card makes contact with the backplane
connector.
5 Push the top and the bottom extractors firmly towards the faceplate to
insert the Hospitality Integrated Voice Services card into the faceplate
connector and to lock the card firmly in place.
6 Observe the red LED at the top of the faceplate (the card LED).
page 62.
End of Procedure