Connections On The Rear Panel - GE Invenia ABUS 2.0 Technical Publication

System Setup

Connections on the Rear Panel

NOTE:
Connection from Invenia ABUS 2.0 to a DICOM destination on a network
3-42
Accessory equipment connected to the analog and digital
interfaces must be certified according to the respective IEC
standards (e.g. IEC60950 for data processing equipment and
IEC60601-1 for medical equipment). Furthermore, all complete
configurations shall comply with the valid version of the system
standard IEC60601-1-1. Everybody who connects additional
equipment to the signal input part or signal output part of Invenia
ABUS 2.0, configures a medical system, and is therefore
responsible that the Invenia ABUS 2.0 device complies with the
requirements of the valid version of IEC60601-1-1. If in doubt,
consult the technical service department or your local
representative for GE.
You will need one network cable to connect the Invenia ABUS
2.0 to a wall outlet on the hospital's network.
1. Connect one end of the cable to the Ethernet connectors on
Invenia ABUS 2.0.
2. Connect the other end of the cable to the wall outlet.
Invenia ABUS 2.0 – System Setup and Basic Service Manual
4700-0043-00 Rev. 4