Securing The Chassis In A Mid-Mount Configuration - Avaya Virtual Services Platform 9000 Installation Manual

Virtual Services Platform 9010 chassis

Securing the chassis in a mid-mount configuration

Mount the Virtual Services Platform 9010 chassis in a standard two-post or four-post equipment
rack in a mid-mount configuration. You must remove the mounting brackets, and then install them at
the midmount location of the chassis.
About this task
The default configuration is a flush-mount configuration. The rack mounting brackets for the flush-
mount configuration are installed at the factory before the chassis ships.
Select the configuration that best meets your floor plan, room layout, or rack style requirements.
Procedure
1. Remove the mounting brackets attached to the front of the chassis sides.
2. Align the holes on the mid-mount bracket with the holes in the mid-mount location on the
chassis side.
October 2015 Installing the Avaya VSP 9000
Comments on this document? infodev@avaya.com
36