Avaya Virtual Services Platform 9000 Installation Manual page 23

Value
REAR zone:
For Virtual Services Platform
9010, no rear fan controllers exist.
Note:
For VSP 9012, rear fan
controllers exist and the
output displays different
values.
Fan Info:
October 2015
Virtual Services Platform 9010 chassis fundamentals
Extended Zone:
FPGA Highest Temperature
FA Highest Temperature
Mode:
Mode Status:
Highest Temperature
FAN 1
FAN 2
FRONT FAN 1 Unit 1
FRONT FAN 1 Unit 2
FRONT FAN 1 Unit 3
FRONT FAN 1 Unit 4
FRONT FAN 2 Unit 1
FRONT FAN 2 Unit 2
FRONT FAN 2 Unit 3
FRONT FAN 2 Unit 4
Installing the Avaya VSP 9000
Comments on this document? infodev@avaya.com
Description
This information applies only to
second generation modules.
Specifies the temperature of the
FPGA sensors. A value of --
indicates that this sensor is not
available on this slot.
This information applies only to
second generation modules.
Specifies the temperature of the
FA sensor, located on the slice. A
value of -- indicates that this
sensor is not available on this slot.
For VSP 9010, no rear fan zone
exists, as a result, Mode always
displays as NORMAL.
For VSP 9010, no rear fan zone
exists, as a result, the Mode
Status always displays as Normal.
For VSP 9010, no rear fan zone
exists, as a result, the temperature
always reports as 0 C.
Specifies the module type under
card type.
Specifies the module type under
card type.
Specifies the status of a fan in the
first cooling module.
Specifies the status of a fan in the
first cooling module.
Specifies the status of a fan in the
first cooling module.
Specifies the status of a fan in the
first cooling module.
Specifies the status of a fan in the
second cooling module.
Specifies the status of a fan in the
second cooling module.
Specifies the status of a fan in the
second cooling module.
Specifies the status of a fan in the
second cooling module.
23