Siemens UL 1066 Operating Instructions Manual page 327

4
I t Delay time-current relationship based on formula I
I-tripping Instantaneous tripping (short-circuit)
I Operating value for load shedding
ab
I Operating value for load restore
an
I Rated operational short-circuit breaking capacity
cs
I Rated ultimate short-circuit breaking capacity
cu
I Rated short-time withstand current
cw
ID Identification number
IEC International Electrotechnical Commission
I Current setting value for G-tripping
g
I Current setting value for I-tripping
i
I Single-pole short-circuit test current (IT systems)
IT
I Current setting value for N-tripping
N
I Rated current (value of rating plug)
n
I Max. possible rated current
n max
I Current setting value for L-tripping
R
I Current setting value for S-tripping
sd
L1 Phase 1
L2 Phase 2
L3 Phase 3
L-tripping Long-time delayed tripping (overload)
LED Light emitting diode
M Motor
MOC Mechanism Operated Auxiliary Conntacts
N Neutral pole
NC Normally closed contact
NO Normally open contact
N-tripping Neutral (overload) tripping
PIDG Ring lug style (Trademark of AMP)
PZ 3...6 Crimping tool (Weidmüller GmbH)
S Circuit breaker
1/2/3
S1 Contact position-driven auxiliary switch
S10 Switch Electrical Closed
S11 Motor cut-off switch
S12 Motor disconnect switch
S13 Cut-off switch for remote reset
S14 Cut-off switch for shunt trip F1 (fast operation)
S15 Cut-off switch for closing coil CC (fast operation)
S2 Contact position-driven auxiliary switch
S20 Signaling switch for "ready-to-close"
S21 Signaling switch for "closing spring charged"
S22 Signaling switch for 1st shunt trip
(mechanical interlocking module)
1/2/3
4
t = constant
25 – 2