Mitsubishi Electric FR-V500 Series Instruction Manual page 35

Names and functions of the control panel
3.3.7 Copy mode
By using the control panel (FR-DU04
series).
1) Operating procedure
After reading the parameter values from the copy source inverter, connect the control panel to the copy
destination inverter, and write the parameter values.
After writing the parameter values to the copy destination inverter, always reset the inverter, e.g. switch power
off once, before starting operation.
Parameter setting mode
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
MON EXT PU
REV FWD
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
MON EXT PU
REV FWD
CAUTION
1. While the copy function is being activated, the monitor display flickers. The display returns to the lit-
up state on completion of the copy function.
2. If a read error occurs during parameter read, "read error (E.rE1)" is displayed.
3. If a write error occurs during parameter write, "write error (E.rE2)" is displayed.
4. If a data discrepancy occurs during parameter verify, the corresponding parameter number and
"verify error (E.rE3)" are displayed alternately. If the directly preset speed or jog speed setting differs,
"verify error (E.rE3)" flickers. Press
5. When the copy destination inverter is not the FR-V500, "model error (E.rE4)" is displayed.
Reference: It is recommended to perform parameter read after completion of parameter setting. (When
performing auto tuning, it is recommended to perform read after completion of auto tuning.) When the
inverter has been changed, performing parameter write from the control panel fitted to a new inverter
completes parameter setup.
), the parameter values can be copied to another inverter (only the FR-V500
-1
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
MON EXT PU
REV FWD
FR-DU04
-1 CONTROL PANEL
Hz/r
SET
A
V
MON EXT PU
REV FWD
Press for
(Caution 1)
SET
1.5s
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
MON EXT PU
REV FWD
Parameter read
Connect to copy destination inverter.
to ignore this display and continue verify.
SET
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
MON EXT PU
REV FWD
Press for
(Caution 1)
SET
1.5s
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
MON EXT PU
REV FWD
Parameter write
After writing the parameter values,
always reset the inverter prior to
the start of operation.
32
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
MON EXT PU
REV FWD
Press for
(Caution 1)
SET
1.5s
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
MON EXT PU
REV FWD
Parameter verify