Subaru Legacy 2021 Owner's Manual page 79

system.
If it is hard to install the child restraint
system because the anchorage cover
returns to the original position, press the
anchorage cover to the seat cushion until it
is flat.
3. If the child restraint system makes
contact with the head restraint of the rear
seating position where the child restraint
system is to be installed, raise the head
restraint to the extended position. If the
child restraint system still makes contact,
remove the head restraint. For details,
refer to "Head Restraint Adjustment"
FP44.
CAUTION
Store the head restraint that has
been removed in the trunk (Legacy)
or the cargo area (Outback). Do not
place the head restraint in the pas-
senger compartment to prevent it
from being thrown around in the
passenger compartment in a sud-
den stop or a sharp turn.
4. For Outback models, adjust the seat-
back to the upright position.
5. While following the instructions sup-
plied by the child restraint system manu-
facturer, connect the lower hooks onto the
lower anchorages located at " " marks on
the bottom of the rear seatback. When the
hooks are connected, make sure the
adjacent seatbelts are not caught.
Child Restraint Systems
6. If your child restraint system is a
flexible attachment type (which uses tether
belts), push the child restraint into the seat
cushion and pull both left and right lower
tether belts up to secure the child restraint
system by taking up the slack in the belt.
7. Latch the top tether hook onto the
tether anchorage that is located on the rear
shelf (Legacy)/behind the rear seat
(Outback) and tighten the top tether firmly.
For additional instructions, refer to "Top
Tether Anchorages" FP74.
– CONTINUED –
73
1