Subaru Legacy 2021 Owner's Manual page 146

140
Door Locks
& Automatic Door Locking/Un-
locking
All doors and the fuel filler lid are auto-
matically locked or unlocked under the
following conditions.
. For automatic door locking
– When the vehicle speed reaches 12
mph (20 km/h) or higher (factory
default setting).
– When the select lever is shifted into
a position other than the "P" position.
. For automatic door unlocking
– When the driver's door is open
(factory default setting).
– When the ignition switch is turned to
OFF.
– When the select lever is shifted into
the "P" position.
NOTE
. The automatic door lock and unlock
setting can be changed with the center
information display. Refer to "Car set-
tings" FP220 (11.6-inch display mod-
els) or "Vehicle setting icons" FP239
(dual 7.0-inch display models).
. When locking the door by the power
door locking switches, automatic door
locking will not operate.
. When unlocking the door by the
power door locking switches, auto-
matic door unlocking will not operate.
. If the system detects a strong en-
ough impact to deploy the airbags, all
doors may be automatically unlocked.
For further details, refer to "Automatic
Door Locking/Unlocking Operation
When Involved in an Accident" FP470.
. When getting out of the vehicle from
a rear door, make sure to unlock all the
doors by pushing the unlock side of the
power door locking switch. If a rear
door is unlocked from the inside door
lever then the door is opened and
closed, the Key lock-in prevention
function will be triggered. All doors will
be unlocked, the Key lock-in prevention
warning indicator " " will appear and
the warning chime will also sound.
& Key Lock-In Prevention
Function
Under the following conditions, all the
doors will not lock when the power door
locking switch is pushed with a front door
open.
. The key is still in the ignition switch
(models without "keyless access with
push-button start system").
. The ignition switch is in the "ACC" or
"ON" position (models with "keyless ac-
cess with push-button start system").
NOTE
. When leaving the vehicle, make sure
you are holding the key before locking
the doors.
. When getting out of the vehicle from
a rear door, make sure to unlock all the
doors by pushing the unlock side of the
power door locking switch.
. When getting out of the vehicle from
a rear door, make sure to unlock all the
doors by pushing the unlock side of the
power door locking switch. If a rear
door is unlocked from the inside door
lever then the door is opened and
closed, the Key lock-in prevention
function will be triggered. All doors will
be unlocked, the Key lock-in prevention
warning indicator " " will appear and
the warning chime will also sound.
. The factory setting (default setting)
for this function is set as "operational".
This function's operational/non-opera-
tional setting can be changed by a
SUBARU dealer. Contact a SUBARU
dealer for details.
! Non-operation of key lock-in pre-
vention function
When the system is set so that it does not
operate, the doors are locked by the
following operation.
. If the lock lever is turned to the front