Subaru Legacy 2021 Owner's Manual page 441

NOTE
The tightening torque is approximately
8.9 + 2.2 lbf·ft (12 + 3.0 N·m, 1.2 + 0.3
kgf·m).
7. Install the plastic plug by pushing it into
the hole until it is fully seated.
! How to re-stow bars
CAUTION
Do not use the bars as roof rails
when the bars are stowed.
1. Check that the rear crossbar is stowed
in the front side holder.
2. Pull out the crossbars from the roof rail
holders by pulling up the covers.
3. Slide the bars in the direction shown in
the illustration.
Loading Your Vehicle
4. Install the bars into the holders.
5. Make sure that the latches are fitted
securely.
435
8