Subaru Legacy 2021 Owner's Manual page 181

"LOCK"/"OFF" or "ACC" position, the
fuel gauge will light up and indicate the
amount of fuel remaining in the tank.
The gauge will turn off when the TRIP
RESET switch is not operated for
approximately 10 seconds.
& Engine Coolant Temperature
Gauge
1) Normal operating range
The temperature gauge shows engine
coolant temperature when the ignition
switch is in the "ON" position.
The coolant temperature will vary in
accordance with the outside temperature
and driving conditions.
We recommend that you drive moderately
until the pointer of the temperature gauge
reaches near the middle of the range.
Engine operation is optimum with the
engine coolant at this temperature range
and high revving operation when the
engine is not warmed up enough should
be avoided.
CAUTION
If the pointer exceeds the normal
operating range, safely stop the
vehicle as soon as possible.
Refer to "Engine Overheating"
FP460.
& Combination Meter Settings
Meter settings can be set on the center
information display. For details, perform
the procedures described in "General
settings" FP216 (11.6-inch display mod-
els) or "General settings" FP234 (dual
7.0-inch display models).
Illumination Brightness Control
3-5. Illumination Brightness
Control
The illumination brightness of the combi-
nation meter and center information dis-
play dims under the following conditions.
. The light switch is in the "
position when the ambient light is dark.
. The light switch is in the "AUTO"
position and the headlights illuminate
automatically.
You can adjust the illumination brightness
for better visibility.
To brighten, turn the control dial upward.
To darken, turn the control dial downward.
– CONTINUED –
175
3
" or " "