Subaru Legacy 2021 Owner's Manual page 178

172
Hazard Warning Flasher
– Do not touch the push-button
ignition switch with a hand
that is soiled with oil or other
contaminants.
. If the push-button ignition switch
does not operate smoothly, stop
the operation. Contact a SUBARU
dealer immediately.
. If the operation indicator on the
push-button ignition switch does
not illuminate even when the
instrument panel illumination is
turned on, have the vehicle in-
spected at a SUBARU dealer.
. If the vehicle was left in the hot
sun for a long time, the surface of
the push-button ignition switch
may get hot. Be careful not to
burn yourself.
NOTE
. When operating the push-button
ignition switch, firmly press it all the
way.
. If the push-button ignition switch is
pressed quickly, the power may not
turn on or off.
. If the indicator light on the push-
button ignition switch flashes in green
when the push-button ignition switch is
pressed, steering is locked. When this
occurs, press the push-button ignition
switch while turning the steering wheel
left and right.
! Battery drainage prevention func-
tion
When the push-button ignition switch is left
in the "ACC" or "ON" position for approxi-
mately 1 hour, the push-button ignition
switch will be automatically switched to
"OFF" to prevent the battery from going
dead. This function is activated when the
select lever is in the "P" position.
& When Access Key Fob Does
Not Operate Properly
Refer to "Access Key Fob – If Access Key
Fob Does Not Operate Properly" FP465.
3-3. Hazard Warning Flasher
The hazard warning flasher is used to warn
other drivers when you have to park your
vehicle under emergency conditions. The
hazard warning flasher works with the
ignition switch in any position.
To turn on the hazard warning flasher,
press the hazard warning flasher switch on
the instrument panel. All the turn signal
lights and the turn signal indicator lights
will flash. To turn off the flasher, press the
switch again.
NOTE
When the hazard warning flasher is on,
the turn signals do not work.