Subaru Legacy 2021 Owner's Manual page 274

268
Mirrors
! R e p r o g r a m m i n g a S i n g l e
HomeLink button
®
To program a previously trained button,
follow these steps:
1. Press and hold the desired HomeLink
button. DO NOT release the button.
2. The indicator light will begin to slowly
flash orange after 20 seconds. The
HomeLink button can be released at this
®
point. Proceed with "Programming a New
HomeLink button" - step 3.
®
3. If you do not complete the program-
ming of a new device to the button, it will
revert to the previously stored program-
ming.
! Garage Door Two-Way Commu-
nication
HomeLink has the capability of commu-
®
nicating with your garage door opener.
HomeLink can receive and display "clos-
®
ing" or "opening" status messages from
compatible garage door opener systems.
At any time, HomeLink can also recall and
®
display the last recorded status commu-
nicated by the garage door opener to
indicate your garage door being "closed"
or "opened".
HomeLink has the capability of receiving
®
this communication from the garage door
opener at a range up to 820 feet (250 m).
Range may be reduced by obstacles such
as houses or trees. You may have to slow
your vehicle speed to successfully receive
the garage door opener communication.
! Programming Two-Way Commu-
®
nication
1) Status Indicators
Within 5 seconds after programming a new
HomeLink button, both of HomeLink's
®
garage door status indicators will flash
rapidly green indicating that the garage
door two-way communication has been
enabled. If your garage door status in-
dicators flashed, two-way communication
programming is complete.
If the garage door status indicators do not
flash, additional HomeLink
and programming videos can be found
online at www.HomeLink.com and
www.youtube.com/HomeLinkGentex.
! Using Two-Way Communication
1) Status Indicator
Recall and display (at any time) the last
recorded garage door status message
communicated to HomeLink
neously pressing HomeLink
and 2 for 2 seconds. HomeLink
display the last recorded status for 3
seconds.
If two-way communication programming is
successful, HomeLink
status of your garage door opener with
arrow indicators (see below).
information
®
by simulta-
®
buttons 1
®
will
®
will display the
®