Subaru Legacy 2021 Owner's Manual page 270

264
Mirrors
Compass calibration zones (South Amer-
ica)
3. To adjust for compass zone variance:
(1) Find your current location and
zone number on the map.
(2) Press and hold the "
more than 6 seconds or until a zone
number appears in the display.
(3) Once the zone number appears in
the display, toggle the "
again until your current location zone
number appears. After you stop press-
ing the switch, your new zone number
will be saved. Within a few seconds,
the display will show a compass direc-
tion.
4. If the vehicle's magnetics have chan-
ged or if the compass appears inaccurate,
recalibrate the compass. Press and hold
the " " switch for more than 9 seconds or
until a "C" appears in the display. Once a
"C" appears in the display, slowly drive the
vehicle in circles until compass is cali-
brated.
! HomeLink
tem
The HomeLink
provides a convenient way to replace up to
three hand-held radio frequency remotes
used to activate devices such as gate
operators, garage door openers, entry
door locks, security systems, even home
lighting. The below steps are generic
programming instructions; for Genie and
Sommer garage door openers please go
directly to the HomeLink
tional information and programming vi-
" switch for
deos can be found at www.HomeLink.
com and www.youtube.com/HomeLink-
Gentex.
" switch
. Before programming HomeLink
to a garage door opener or gate
operator, make sure that people
and objects are out of the way of
the device to prevent potential
harm or damage.
. When programming a garage
Wireless Control Sys-
®
Wireless Control System
®
website. Addi-
®
CAUTION
®
door opener, it is advised to park
outside of the garage.
. Do not use HomeLink
garage door opener that lacks
safety stop and reverse features
as required by U.S. federal safety
standards (this includes any gar-
age door opener model manufac-
tured before April 1, 1982). A
garage door that cannot detect
an object signaling the door to
stop and reverse does not meet
current U.S. federal safety stan-
dards.
. It is also recommended that a new
battery be placed in the hand-
held remote (garage door opener
remote) of the device for quicker
and more accurate training.
. Turn the ignition switch to the
"ON" or "ACC" position before
programming and/or operating
HomeLink .
®
. Keep the hand-held remote (gar-
age door opener remote) of the
device you are programming for
use in other vehicles as well as
for future HomeLink
®
ming. It is also suggested that
upon the sale of the vehicle, the
programmed HomeLink
with any
®
program-
buttons
®