Table of Contents
Advertisement
Setting the Automatic White Balance Feature
1. Select Camera / Lens Functions from the Dome Configuration Menu.
2. Use the Tilt control to move the highlight bar to the Auto White Bal setting.
3. Press Zoom Out or Zoom In to change the setting.
4. Do one of the following:
Changing the Red and Blue Settings
Note
1. Select Camera / Lens Functions from the Dome Configuration Menu.
2. If you want to make changes to the red setting, use the Tilt control to move the highlight
bar to Red White Bal, then continue with step 3.
If you want to make changes to the blue setting, continue with step 4.
3. Press Zoom In or Zoom Out to adjust the setting. The values range from 128 to 1023.
4. Do one of the following:
4
This command is not supported with Manchester.
3-6
If you want the white balance to be automatic, select On.
If you want manually adjust the red or blue settings, select Off. Then continue
with Changing the Red and Blue Settings on page 3-6.
The default setting is On.
If you want to make changes to the line lock setting, refer to Setting Line Lock on
page 3-2.
If you want to make changes to the automatic gain control settings, refer to
Automatic Gain Control Settings on page 3-3.
If you are finished making changes, press and hold Iris Close, then press Focus
Near or Focus Far to save your changes and exit the utility.
If you want to make changes to other settings, use the Tilt control to move the
highlight bar to Exit, then press Focus Far. The Dome Configuration Menu
appears. Continue with What To Do Next on page 3-8.
Auto White Bal must be set to Off to make changes to this setting.
Press Zoom In to increase the value of the setting.
Press Zoom Out to decrease value of the setting.
There is no default value for the red setting.
If you want to make changes to the blue setting, use the Tilt control to move the
highlight bar to Blue White Bal, then continue with step 5.
4
Operator's Manual
Advertisement
Table of Contents
