American Dynamics AD615 Operator's Manual page 37

4. Use Pan Right to move the highlight bar to the Number field, then press Zoom In or Zoom
Out to change the setting.
5. Use the Tilt control to move the highlight bar to Return Time Mins. Press Zoom Out or
Zoom In to set the amount of time that the dome must remain inactive before returning to
the home position.
The range for the setting is 1 to 60 minutes.
The default setting is 10 minutes.
6. Use the Tilt control to move the highlight bar to Exit. Press Focus Far to return to the
Alarms/Areas/Home screen. Continue with step 7.
7. When the Alarms/Areas/Home screen appears, do one of the following:
4
This command is not supported with Manchester.
4-8
If you want the home position to be a preset, select Preset, then continue with
step 4.
If you want the home position to be a pattern, select Pattern, then continue with
step 4.
If you do not want to set a home position, select No Action, then continue with
step 6.
The default setting is No Action.
If the home position is a preset, select the number from 1 through 96 (1 through
64 for Manchester domes) for the preset you want to assign.
If the preset has not been programmed, preset programming automatically starts.
Refer to Programming Presets on page
4-11.
If the preset has been programmed, continue with step 5.
If the home position is a pattern, the select the number from 1 through 3 for the
pattern you want to assign. Continue with step 5.
If you want to configure the alarm actions, continue with Configuring Alarm
Actions on page 4-2.
If you want to configure the input states, continue with Configuring Normal
Input States on page 4-5.
If you want to define areas, continue with Programming Area Boundaries on
page 4-9.
If you want to define presets, continue with Programming Presets on page 4-11.
If you are finished making changes, press and hold Iris Close, then press Focus
Near or Focus Far to save your changes and exit the utility.
If you want to make changes to other settings, use the Tilt control to move the
highlight bar to Exit, then press Focus Far. The Dome Configuration Menu
appears. Continue with What To Do Next on page 4-14.
4
Operator's Manual