American Dynamics AD615 Operator's Manual page 33

The highlight bar appears on the Set Alarm Actions option. Press Focus Far to select.
2. Use the Tilt control to move the highlight bar to the appropriate alarm input.
3. Press Zoom In or Zoom Out to change the setting.
4. Use Pan Right to move the highlight bar to the Action Number field, then press Zoom In
or Zoom Out to change the setting.
5. If you need to make additional changes to the alarm actions for this dome repeat steps 3
through 5. When finished, continue with step 6.
6. Use the Tilt control to move the highlight bar to Send Inputs to Host?
7. Press Zoom In or Zoom Out to change the setting.
8. Use the Tilt control to move the highlight bar to Exit. Press Focus Far to return to the
Alarm/Areas/Home screen, then continue with step 9.
9. When the Alarm/Areas/Home screen appears, do one of the following:
1
This setting does not apply to Manchester.
4-4
If you want the action to be a preset, choose Preset then continue with step 4.
If you want the action to be a pattern, choose Pattern then continue with step 4.
If you do not want a special action for this input, choose No Action then
continue with step 5.
The default setting is No Action.
If the alarm action is a preset, select the number (1 through 96) for the preset you
want to assign.
If the preset has not been programmed, preset programming automatically starts.
Refer to Programming Presets on page 4-11.
If the preset has been programmed, continue with step 5.
If the alarm action is a pattern, then select the number (1 through 3) for the
pattern you want to assign. Then continue with step 5.
If you want changes in the input states to be forwarded to the host controller,
1
choose Yes. Continue with step 8.
If you do not want changes in the input states to be forwarded to the host
controller, choose No. Continue with step 8.
The default setting is Yes.
If you want to configure the input states, continue with Configuring Normal
Input States on page 4-5.
If you want to set the "home" position, continue with Assigning the Dome's
Home Position on page 4-7.
If you want to define areas, continue with Programming Area Boundaries on
page 4-9.
If you want to define presets, continue with Programming Presets on page 4-11.
Operator's Manual