Displaying Diagnostic Tests During Reset - American Dynamics AD615 Operator's Manual

Deltadome programmable surveillance camera
Hide thumbs Also See for AD615:
Table of Contents

Advertisement

7. The following prompt appears on the screen:
8. Do one of the following:
9. Do one of the following:

Displaying Diagnostic Tests During Reset

You can choose to have dome diagnostic tests run whenever the dome resets. The diagnostic
information displayed includes:
Communications Loopback Test
Camera Loopback Test
Motor Circuit Test.
If you do not want diagnostic information to appear when the dome resets, a screen
displaying the firmware version numbers for the Boot and Application code and the
maximum optical zoom for the dome appears.
3
This command is not supported with Manchester.
5-6
RESET PROGRAMMABLE NAMES NO
Press Zoom In or Zoom Out to toggle the setting.
To reset all names to the default value, select Yes, then press Focus Far. The
Name Configuration Menu displays. "Programmable Names Have Been
Reset" appears at the bottom of the screen.
To cancel resetting of names, select No, then press Focus Far. The Name
Configuration Menu displays.
The default selection is No.
If you want to change programmable name information, continue with Assigning
or Changing Name Information on page 5-7.
When you finish making changes, use the Tilt control to move the highlight bar
to Exit. Then press Focus Far to return to the On-Screen Text Display form.
Continue with step 9.
If you want to change the display of status information, refer to Displaying or
Hiding Status Information on page 5-2.
If you want diagnostic information to appear when the dome resets, refer to
Displaying Diagnostic Tests During Reset on page 5-6.
If you want to change the appearance of the text information, refer to Changing
Text Display Attributes on page 5-10.
If you are finished making changes, press and hold Iris Close, then press Focus
Near or Focus Far to save your changes and exit the utility.
If you want to make changes to other settings, use the Tilt control to move the
highlight bar to Exit, then press Focus Far. The Dome Configuration Menu
appears. Continue with What To Do Next on page 5-12.
3
Operator's Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ad616

Table of Contents