Changing The Display Of Selected Name Information - American Dynamics AD615 Operator's Manual

Changing the Display of Selected Name Information

When Name Configuration Menu is selected from the On-Screen Text Display screen,
the following appears:
RESET PROGRAMMABLE NAMES
Figure 5-4: Name Configuration Screen
You can choose to enable or disable the display of camera, area, preset, pattern, and alarm
names from this screen. You can reset all programmable names to their default settings. You
can also initiate name programming from this screen (see Assigning or Changing Name
Information on page 5-7).
To change the display of a name:
1. Select On-Screen Text Display from the Dome Configuration Menu.
2. Use the Tilt control to move the highlight bar to Name Configuration Menu. Then press
Focus Far.
The Name Configuration Menu appears.
3. Use the Tilt control to move the highlight bar to the item whose display setting you want
to change.
4. Press Zoom In or Zoom Out to change the setting.
5. Repeat steps 3 and 4 for each item you want to change.
6. Do one of the following:
On-Screen Text Display Settings
NAME CONFIGURATION MENU
CAMERA NAME
AREA NAME
PRESET NAME
PATTERN NAME
ALARM NAME
EXIT
FOCUS FAR to program name
If you want the name to appear on the monitor, choose On.
If you do not want the name to appear on the monitor, choose Off.
The default settings are Off for Camera, Areas, Presets, and Patterns, and
On for Alarms.
If you want to reset all programmable names to their default values, use the Tilt
control to move the highlight bar to Reset Programmable Names, then press
Focus Far. Continue with step 7.
If you do not want to reset the programmable names, continue with step 8.
Highlight Bar:
Move with Tilt
OFF
control. Press
Focus Far to
OFF
change name.
OFF
OFF
ON
5-5