American Dynamics AD615 Operator's Manual page 42

Figure 4-8: Program Preset screen
4. Use the Pan and Tilt controls to move the camera until you see the scene you want to use
as the preset. Adjust the zoom and iris settings as necessary. Press Focus Far to save the
preset.
5. Repeat steps 3 and 4 for each preset you want to program. When finished, use the Tilt
control to move the highlight bar to Exit, then press Focus Far.
6. When the Alarms/Areas/Home screen appears, do one of the following:
1
This command is not supported with Manchester.
Alarms, Areas and Home Settings
PROGRAM PRESET
Position camera with PAN,
TILT, ZOOM, and IRIS
FOCUS FAR to save and exit
If you want to configure the alarm actions, continue with Configuring Alarm
Actions on page 4-2.
If you want to configure the input states, continue with Configuring Normal
Input States on page 4-5.
If you want to set the "home" position, continue with Assigning the Dome's
Home Position on page 4-7.
If you want to set areas, continue with Programming Area Boundaries on page
4-9.
If you are finished making changes, press and hold Iris Close, then press Focus
Near or Focus Far to save your changes and exit the utility.
If you want to make changes to other settings, use the Tilt control to move the
highlight bar to Exit, then press Focus Far. The Dome Configuration Menu
appears. Continue with What To Do Next found on page 4-14.
PRESET 96
EXIT
6
4-13