Overview Of On-Screen Text Display Settings; Displaying Or Hiding Status Information - American Dynamics AD615 Operator's Manual

Overview of On-Screen Text Display Settings

When On-Screen Text Display is selected from the Dome Configuration Menu, the
following screen is displayed:
STATUS DISPLAY
DISABLE ALL NAMES?
NAME CONFIGURATION MENU
Figure 5-1: On-Screen Text Display
From this screen you can choose to display status information about the dome, choose to
enable or disable the display of all name information, and choose to display diagnostic
information after a dome reset. You can start the Name Configuration Menu and the Text
Attribute Options screens.
To move the highlight bar, use the Tilt control.
Pressing Zoom Out or Zoom In changes value of the selected setting.
When you finish making changes, move the highlight bar to Exit, then press Focus Far
to return to the Dome Configuration Menu.

Displaying or Hiding Status Information

You can choose to display the status of the zoom setting, auto focus, and auto iris. This
information will appear in the upper left corner of the monitor. The information only appears
when there is a change in the status of any item and remains on the screen for 5 seconds. If
"D" appears next to the zoom factor, the digital zoom is active (zooms greater than 16X).
ZOOM X18D
AUTO IRIS ON/OFF
AUTO FOCUS ON/OFF
Figure 5-2: Example of Zoom, Auto Focus and Auto Iris Status Information
5-2
ON-SCREEN TEXT DISPLAY
TEXT ATTRIBUTE OPTIONS
EXIT
Highlight Bar:
OFF
Move with Tilt
NO control
Operator's Manual