Interference Or Distortion Appear In Images; The Image Is Truncated (Large) Or Small, The Aspect Is Not Suitable, Or The Image Has Been Reversed - Epson EB-L1505UHNL User Manual

Problem Solving

Interference or distortion appear in images

Check
Are the cables connected correctly?
Is an extension cable being used?
Is the correct resolution selected?
(Only when projecting computer images)
g g
Are the Sync. and Tracking settings adjusted correctly?
(Only when projecting computer images)
Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)

The image is truncated (large) or small, the aspect is not suitable, or the image has been reversed

Check
Have the Screen been set correctly?
Is the aspect adjusted correctly?
Is a wide panel computer image being projected?
(Only when projecting computer images)
Is the image still being enlarged by E-Zoom?
Is Scale turned on?
Check that all the cables required for projection are securely connected.
s "Connecting Equipment" p.48
If an extension cable is used, electrical interference may affect the signals.
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.266
s Computer's documentation
Press the [Auto] button on the Remote Control or the [
adjustment. If the images are not adjusted correctly even after performing automatic adjustment, you can also make
adjustments from the Configuration menu.
s Signal - Tracking, Sync. p.146
The image may be collapsed if the Resolution on the Configuration menu and the resolution of the projected image are
not the same.
If the image is collapsed, set the Resolution to Auto.
s Signal - Resolution p.146
Make the appropriate Screen for the screen being used.
s "Screen Settings" p.31
Press the [Aspect] button to select an aspect suitable for the input source.
s "Changing the Aspect Ratio of the Projected Image"
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.146
Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)"
Set Scale to Off on the configuration menu.
s Signal - Scale Scale p.146
Remedy
] button on the Control panel to perform automatic
Remedy
p.81
p.112
196