F.1.4 Network Management Parameters - Alvarion BreezeACCESS VL System Manual

Parameter
Antenna Gain
Spectrum Analysis
Channel Scan Period
Spectrum Analysis Scan
Cycles
Automatic Channel
Selection
Lost Beacons Watchdog
Threshold
Noise Immunity State
Control
Noise Immunity Level
Spur Immunity Level
OFDM Weak Signal
Pulse Detection
Sensitivity
* Not applicable if only one Sub-Band is available for the applicable Country Code
** Applicable only if DFS is supported by the Sub-Band
*** Configurable only in units without an integral antenna.
F.1.4 Network Management Parameters
Parameter
Access to Network
Management
Network Management
Filtering
Set Network Management IP
Address
Set/Change Network
Management IP Address
Ranges
Send SNMP Traps
BreezeACCESS VL System Manual
Unit Range
AU, 0 – 50 (dB)
SU***
AU, SU 2 – 30 seconds
AU, SU 1 – 100 cycles
AU Disable
Enable
AU 100 – 1000, 0 means Not
Used
AU, SU Automatic
Manual
AU, SU 0 – 4
Use only 0 or 4
AU, SU 0 – 7
AU, SU 0 (not active) or 1 (active)
AU, SU Low
High
Unit Range
AU, SU From Wireless Link Only
From Ethernet Only
From Both Ethernet and
Wireless Link
AU, SU Disable
Activate Management IP
Filter On Ethernet Port
Activate Management IP
Filter On Wireless Port
Activate Management IP
Filter On Both Ethernet
and Wireless Ports
AU, SU IP address
AU, SU <start address> to <end
address>
or,
<base address> mask <mask>
AU, SU Disable
Enable
Parameters Summary
Default
According to the antenna
supplied with the unit.
5 seconds
2 cycles
Disable
218
Automatic
0
0
0
High
Default
From Both Ethernet No
and Wireless Link
Disable No
0.0.0.0 No
(all 10 entries)
0.0.0.0 TO 0.0.0.0 No
(all 10 entries)
Disable Yes
Run-Time
No
No
No
No
(Configured
per
analysis)
Yes
Yes
Yes
Yes
Yes
Yes
Run-Time
269