Alvarion BreezeACCESS VL System Manual page 191

The range is from 1 to 60 minutes.
The default is 5 minutes.
4.2.6.4.4 Bridge Aging Time
The Bridge Aging Time parameter enables selecting the bridge aging time for
learned addresses of devices on both the wired and wireless sides, not including
BreezeACCESS VL units.
The available range is 20 to 2000 seconds.
The default value is 300 seconds.
4.2.6.4.5 Broadcast Relaying (AU only)
The Broadcast Relaying option enables selecting whether the unit performs
broadcast relaying. When the Broadcast Relaying parameter is enabled,
broadcast packets originating from devices on the wireless link are transmitted by
the AU back to the wireless link devices, as well as to the wired LAN. If disabled,
these packets are sent only to the local wired LAN and are not sent back to the
wireless link. Disable the broadcast relaying only if all broadcast messages from
the wireless link are certain to be directed to the wired LAN.
The default selection is Enable.
4.2.6.4.6 Unicast Relaying (AU only)
The Unicast Relaying option enables selecting whether the unit performs unicast
relaying. When the Unicast Relaying parameter is enabled, unicast packets
originating from devices on the wireless link can be transmitted back to the
wireless link devices. If disabled, these packets are not sent to the wireless link
even if they are intended for devices on the wireless link. Disable the Unicast
Relaying parameter only if all unicast messages from the wireless link are certain
to be directed to the local wired LAN.
The default selection is Enable.
4.2.6.4.7 MAC Address List (AU only)
The MAC Address List submenu enables to define a list of up to 100 MAC
addresses as belonging to devices that are either granted or denied service. When
the list is defined as a Deny List, the AU will not provide services to a unit whose
MAC address is included in the list, enabling to disconnect units in cases such as
when the user had fraudulently succeeded to configure the unit to values
different from the subscription plan. When the list is defined as an Allow List, the
AU will provide services only to units with a MAC address that is included in the
list.
The MAC Address List submenu includes the following:
Operation and Administration
Menus and Parameters
165