Snmp Traps - Alvarion BreezeACCESS VL System Manual

Chapter 4 - Operation and Administration

4.2.6.3.7 SNMP Traps

The SNMP submenu enables or disables the transmission of SNMP Traps. If this
option is enabled, up to 10 IP addresses of stations to which SNMP traps are sent
can be defined.
4.2.6.3.7.1 Send SNMP Traps
The Send SNMP Traps option enables or disables the sending of SNMP traps.
The default selection is Disable.
4.2.6.3.7.2 SNMP Traps Destination IP Addresses
The SNMP Traps Destination IP Addresses submenu enables defining up to 10 IP
addresses of devices to which the SNMP Traps are to be sent.
The default of all 10 SNMP Traps IP destinations is 0.0.0.0.
4.2.6.3.7.3 SNMP Traps Community
The SNMP Traps Community option enables defining the Community name for
each IP address to which SNMP Trap messages are to be sent.
Valid strings: Up to 8 ASCII characters.
The default for all 10 addresses is "public", which is the default Read community.
4.2.6.3.7.4 Delete One Trap Address
The Delete One Trap Address option enables deleting Trap address entries from
the SNMP Traps Addresses list.
4.2.6.3.7.5 Delete All Trap Addresses
The Delete All Trap Addresses option enables deleting all entries from the SNMP
Traps Addresses list.
4.2.6.3.8 AP Client IP Address (SU Only)
The BreezeACCESS WI
advanced WiFi Access Point and a BreezeACCESS SU-ODU that provides
backhaul connectivity. The AP Client IP Address parameter enables the installer
to configure in the SU the IP address of the WiFi AP connected to it, providing
availability of the IP address information for remote management of the AP.
The default AP Client IP Address is 0.0.0.0 (meaning none).
150
system comprises a self-contained combination of an
2
BreezeACCESS VL System Manual