MIB Parameter
*MaximumBurstDuration
(*CountryDependentParameterEntry 9)
*DfsSupport
(*CountryDependentParameterEntry 10)
*MinimumHwRevision
(*CountryDependentParameterEntry 11)
*AuthenticationEncryptionSupport
(CountryDependentParameters 3)
*DataEncryptionSupport
(CountryDependentParameters 4)
*AESEncryptionSupport
(CountryDependentParameters 5)
*AntennaGainChange
(*SysInfo 19)
E.2.2
Unit Control Parameters
MIB Parameter
*UnitControl
(breezeAccessVLMib 2)
*ResetUnit
(*UnitControl 1)
*SetDefaults
(*UnitControl 2)
BreezeACCESS VL System Manual
Description
Applicable to all units.
Read only. Applicable only
if Burst Mode Option is
supported. The maximum
supported burst duration.
Applicable to AU/BU only.
Read only. The supported
DFS Option.
Applicable to all units.
Read only. The Minimum
HW Revision needed to
support the Sub-Band.
Applicable to all units.
Read only. The supported
Authentication Encryption
Option.
Applicable to all units.
Read only. The supported
Data Encryption Option.
Applicable to all units.
Read only. The supported
AES Encryption Option.
Applicable to all units.
Indicates whether the
Antenna Gain parameter is
changeable of fixed.
Description
Applicable to all units. Resets the
unit and applies new parameter
values.
Applicable to all units. Sets unit
configuration to Defaults values
after the next reset.
completeFactory: All parameters
revert to Factory Defaults values
partialFactory: All parameters
revert to Factory Defaults values,
except the parameters required
for maintaining wireless
connectivity.
completeOperator: All parameters
revert to Operator Defaults values
partialOperator: All parameters
revert to Operator Defaults
values, except the parameters
required for maintaining wireless
connectivity.
breezeAccessVLMib
Value/Range
Integer
Integer
supported (1)
notSupported (2)
Integer
hwRevisionA (1),
hwRevisionB (2),
hwRevisionC (3),
hwRevisionD (4),
hwRevisionE (5),
na (255)
Integer
supported (1)
notSupported (2)
Integer
supported (1)
notSupported (2)
Integer
supported (1)
notSupported (2)
Integer
supported (1)
notSupported (2)
Value/Range
Integer
cancel (1)
resetSystemNow (2)
Integer
NoDefaultSettingRequested (0),
completeFactory (1)
partialFactory (2)
completeOperator (3)
partialOperator (4)
cancelCurrentPendingRequest
(5)
215