Data Communication; Table 1-7: Data Communication - Alvarion BreezeACCESS VL System Manual

Chapter 1 - System Description
1
The actual available frequency channels and bandwidth are defined by the selected Sub-Band, which reflects the
applicable regulatory constraints. For more details refer to section 4.2.2.4).
2
The actual maximum available output power for each modulation level is defined by the selected Sub-Band, which
reflects the applicable regulatory constraints. For some countries the power may also be limited by limitations on
the maximum EIRP (also included in the Sub-Band parameters) and the Antenna Gain parameter. For more details
refer to section 4.2.2.4 and to section
the Country Codes document.
3
The sensitivity values are for a bandwidth of 20 MHz. When using a 10 MHz bandwidth, the sensitivity for each
modulation level is 3 dB lower.
4
Modulation Level indicates the radio transmission rate and the modulation scheme. Modulation Level 1 is for the
lowest radio rate and modulation scheme.
5
Modulation Level 8 is supported only in units with HW Revision B and above.
1.7.2

Data Communication

Item
Standard compliance
VLAN Support
Layer-2 Traffic Prioritization
Layer-3 Traffic Prioritization
Layer 4 Traffic Prioritization
16
4.2.6.2.8.1. For information on specific HW and Country Code limitations, see
4

Table 1-7: Data Communication

IEEE 802.3 CSMA/CD
Based on IEEE 802.1Q
Based on IEEE 802.1p
IP Precedence ToS (RFC791)
DSCP (RFC2474)
UDP/TCP destination ports
Description
BreezeACCESS VL System Manual